140CRP93100 Description

For more information about 140CRP93100, please visit my store home page http://xrd0196.pack.CN Contact: Zheng Gong - 0196 Contact QQ
Main: world famous brand PLC, DCS system spare parts module 〖1〗 Allen-Bradley (USA AB) series products》
〖2.〗 Schneider (Schneider Electric Series)
〖3. General electric series products』
〖4.〗 Westinghouse (United States Westinghouse series products)
〖5.〗 SIEMENS (Siemens series products)
〖6.〗 Sales of ABB Robots. FANUC Robots, YASKAWA Robots, KUKA Robots, Mitsubishi Robots, OTC Robots, Panasonic Robots, MOTOMAN Robots.
〖7.〗 estinghouse (Westinghouse): OVATION system, WDPF system, MAX1000 system spare parts.
〖8. Invensys Foxboro: I/A Series system, FBM (field input/output module) sequential control, ladder logic control, accident recall processing, digital-analog conversion, input/output signal processing, data communication, and processing Wait. Invensys Triconex: Redundant fault-tolerant control system, the most modern fault-tolerant controller based on Triple Modular Redundancy (TMR) architecture.
〖9.〗 Siemens (Siemens): Siemens MOORE, Siemens Simatic C1, Siemens CNC system and so on.
〖10.〗 Bosch Rexroth (Bosch Rexroth): Indramat, I/O module, PLC controller, drive module, etc.
〖11.〗 Motorola: MVME 162, MVME 167, MVME1772, MVME177 and other series.
Contact: Zheng Gong

WARNING ̈ Unqualified personnel working on the drive's devices/systems or failing to follow the "Warning" regulations may cause serious personal injury or major property damage. Only trained and qualified personnel trained in the design, installation, commissioning and operation of the equipment are allowed to work on the equipment/system of the equipment.
̈ The input power cord only allows permanent fastening. The equipment must be grounded (according to IEC 536 Class 1, NEC and other applicable standards).
MM MM440 frequency inverters with dimensions A to F can only use type B ELCB (earth leakage circuit breaker -
EarthLeakage Circuit-Breaker). When the device is supplied by a three-phase power supply and with an EMC filter, the leakage circuit breaker ELCB must not be grounded (see DIN VDE 0160, Section 5.5.2 and EN50178)
Section 5.2.11.1) Connection to the power supply.
̈ Even if the inverter is inoperative, the following terminals may still carry hazardous voltage:
- Power terminals L/L1, N/L2, L3 or U1/L1, V1/L2, W1/L3
- Connect the motor terminals U, V, W or U2/T1, V2/T2, W2/T3
- and terminals DC+ / B+, DC-, B-, DC/R+ or C/L+, D/L-
̈ After the power switch is turned off, it must wait for 5 minutes to allow the frequency converter to discharge before it is allowed to start the installation operation. ̈ This device cannot be used as an 'emergency parking mechanism' (see EN 60204, 9.2.5.4)
最小 The minimum cross-sectional area of ​​the ground conductor must be equal to or greater than the cross-sectional area of ​​the power supply cable. ̈ If the front cover is removed (only MM440 drives with dimensions FX and GX), the blades of the fan are exposed. When the fan is turning, there is a danger of personal injury.
Note that the power supply cables connected to the frequency converter, motor cables and control cables must be connected as shown in Figure 2-13 below to avoid inductive and capacitive interference due to the operation of the frequency converter.